Martin-christ Epsilon 2-10D LSCplus Instrukcja Użytkownika Pobierz pdf (Strona 41)

Freeze-dryer EPSILON 2-10D LSCplus

5 Set-up and connection

Version 04/2013, Rev. 1.5 of 16/12/2014 • sb

Translation of the original operating manual

Pos: 121 /20 0 Ch rist/3 61 G T-BA Labo r-P ilot (PR OJEK TE)/E psilo n S tanda rd/0 50 A ufs tellun g u nd Ansc hl uss/0 50- 007 1 So nderaus s tatt ung: Feinre gel -N adelv entil E psil on @ 25\ mod_ 140 498 463498 1_6 8.docx @ 1 858 05 @ 2 @ 1



5.10 Special equipment: Precision control needle valve for air injection

In addition to the aeration valve, a precision control needle valve is also

installed (position chapter 2.1.1 - ""). The precision control needle valve is

used to pre-adjust the volume flow. If the actual value is below the

preselected vacuum value, this valve will open briefly, thereby ensuring a

constant vacuum in the freeze-dryer.

NOTE

The precision control needle valve is pre-adjusted at the factory. Usually, it

does not require any readjustment.

Pos: 122 /01 0 Uni v ersal mod ule/L eerz ei le @ 0\m od_ 120 211624 450 0_0. doc x @ 11 4 @ @ 1

Pos: 123 /01 0 Uni v ersal mod ule/L eerz ei le @ 0\m od_ 120 211624 450 0_0. doc x @ 11 4 @ @ 1

Pos: 124 /20 0 Ch rist/3 61 G T-BA L abo r-Pi lot (PROJE KTE )/Epsi lo n Sta nda rd/0 50 Aufs tell ung u nd Ans c hluss/0 50- 008 0 Vak uu mpumpe Ep si lon (außer 2- 4) @ 25\ mod _14 049846 362 16_ 68.d ocx @ 185 819 @ 2 @ 1

5.4.6 Vakuum pum pe 

5.11 Vacuum pump

NOTE

Please refer to the separate operating manual of the vacuum pump and

the exhaust filter!

The vacuum pump must be connected to the vacuum connector of the unit.

The electrical connection is located inside the housing next to the vacuum

pump.

The oil mist that escapes when the pump is in operation must be retained

or carried off by way of an oil mist separator.

• We strongly recommend using an oil mist separator. This filter prevents

air pollution by oil mist.

• In order to carry off the oil mist, connect a suitable hose to the exhaust

port of the vacuum pump (RZ-2.5 and RC-6: ½", DUO 5 or DUO 10 ¾").

• The hose must be laid so that the condensate cannot flow back into the

pump. In the case of upward leading hoses, we recommend using a

separator (Woulfe's bottle or wash bottle).

Pos: 125 /01 0 Uni v ersal mod ule/S eit enwec hsel @ 0\m od_ 120 211 624 4312 _0. docx @ 10 5 @ @ 1

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 134 135

Komentarze do niniejszej Instrukcji

Brak uwag

Martin-christ Epsilon 2-10D LSCplus Instrukcja Użytkownika Strona 41

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Ekwipunek Martin-christ Epsilon 2-10D LSCplus